• Call Us

  • Address

    University Drive, Off Idofin Road, Oko-Irese, Kwara State

Bachelor Engineering in Mechanical Engineering

Admission Requirement(s)

A.        Unified Tertiary Matriculations (UTME)

  • Unified Tertiary Matriculations Examination (UTME) is conducted by the Joint Admissions and Matriculations Board (JAMB). A candidate seeking admission into the college through this means must attain at least, the minimum required standard in the entrance examination normally called the ‘cut-off mark’ in the following subjects: English, Mathematics, Physics and Chemistry. This cut-off mark is set by the University admissions board based on information from JAMB on session-by-session basis. Normally, the University wide cut-off mark for a particular session will not be less than the JAMB cut-off mark. In addition, the Faculty of Engineering and Technology as well as the department may have, from time to time, further requirements which may be different but not less than the University wide requirement.

(ii)   In addition to (i), UTME candidates must obtain O’Level credit passes at not more than two sittings in English and at least four science subjects which must include Mathematics, Physics and Chemistry. A credit pass in Further Mathematics will be considered a plus.

  1. Direct Entry (DE)

(i)    DE candidates into 200 level must attain at least the cut-off mark which will be set by the University in its Post-UTME screening examination.

  • In addition to (i), such candidates must obtain A-Level/IJMB or approved equivalent pass in Mathematics, Physics and Chemistry or a National Diploma (ND) in a relevant engineering field (as determined by the department) at distinction or Upper credit level. The ND must be from a recognized Polytechnic or College of Technology with one-year industrial attachment.
  • For DE admission into 300 level, a candidate must possess HND Upper Credit grade (minimum) in addition to (i) and (ii).
Copyright © 2024, Thomas Adewumi University, Oko | All rights reserved.